how to install super shieldz screen protector

Starting from the center, hold the squeegee with your other hand and gently slide it across the screen in an outward motion (avoiding open ports or buttons). Slide it around to match all cutouts and edges. Position the adhesive side face down on your screen.Use your moistened fingertips to peel the MilitaryShield off from its backing and evenly spray onto the sticky adhesive side until there are no dry spots left.Before peeling off the shield, spray your fingertips with the solution to eliminate fingerprints.Evenly spray the non-adhesive side of the MilitaryShield. Know where the cutouts of the MilitaryShield will fit on your device.Reset fingerprint sensor after installation, when device is ready to use is recommended.

As liquid damage could cause corrosion and heat damage can caused the device to malfunction. WARNING: Please don't use excessive liquid or excessive heat as it may cause damage to your device, as we are not responsible for the outcome caused by it.Please use the blow dryer with the lowest/coolest setting for no more then a few minutes for the MilitaryShield to dry the area on the film. This helps dry the shield, making it tackier and allowing it to stick better. The BLOWDRYER Method: You may utilize a blow dryer for rounded corners, tabs and edges when installing the Armorsuit MilitaryShield.Any bubbles or streaks you see after initial application is normal! They should disappear within 3-5 days.Hold it up against the light to see if you've pushed out all large air bubbles. Ensure screen protector lays completely flat on the screen.Install in clean, dust-free environment.Use microfiber cloth to clean your screen.Turn off device and remove battery only if possible.Install MilitaryShield before bedtime to allow for drying overnight.

How to install super shieldz screen protector